BLINKING LED USING 555 IC

            BLINKING LED USING 555 IC

Components required:

                                          1)555 IC
                                          2)10k RESISTOR
                                          3)10uf CAPACITOR
                                          4)DC SUPPLY
                                          5)CONNECTING WIRES

Circuit Diagram:

Procedure:

          The 555 ic is the basic ic which helps in generation of square pulse where it can be adjusted by the resistor and thr capacitor used in it.The frequency can be calculated by formula 1.44/(R1+R2+R2)*C1 where the with of the wave can be controlled.
         The Pin 1 is ground and the pin 2 and pin 6 connected using wire and pin 3 is the output pin where pin 4 and pin 8 is connected using wire and pin 5 is constant and pin 6 and pin 7 joint using 10K resistor and pin 7 and pin 8 is connected using 10K resistor where 10uf capacitor small terminal is connected 2 pin of 555.
         The capacitor +ve pin connected to gnd pin and give the supply to 8 pin where 4 and 8 pin are positive it is connected using wires and -ve supply yo gnd Now the led glows as blinking

LETS CHECK HOW IS IT WORK:

                                                         POWERED BY
                                                                NBSL