Anti-Theft Alarm Using 555 IC
This is an
simple project to prevent the object from thefting. Let us discuss this project
below.
Components Required
1. 555 IC
2. 10K ohm resistor
3. 10uf capacitor
4. LED
5. BreadBoard
6. Connecting Wires
7. 9v Battery
Circuit Diagram
Procedure
· Insert the 555 IC in the breadboard
and then connect resistors and capacitor shown in figure
· Then insert an single piece wire at the 8th terminal of 555 IC
· Then insert the another single piece wire at the 1st terminal of the 555 IC
· Next connect an LED to the 3rd pin of the 555 IC and connect another end of Led to ground
· Now, connect it to the power supply. When the 8th and 1st pin have been shot circuited with the wire the Led doesn’t glows
· When it’s not shoted it glows and we can connect it to the buzzer and use it as antitheft alarm.
· Then insert an single piece wire at the 8th terminal of 555 IC
· Then insert the another single piece wire at the 1st terminal of the 555 IC
· Next connect an LED to the 3rd pin of the 555 IC and connect another end of Led to ground
· Now, connect it to the power supply. When the 8th and 1st pin have been shot circuited with the wire the Led doesn’t glows
· When it’s not shoted it glows and we can connect it to the buzzer and use it as antitheft alarm.
Note: When 8th and 1st pin shoted the power goes directly positive to negative orelse it goes another way so the led glows.
Working Video
POWERED BY
NBSL
nice
ReplyDelete